Honeywell Gas Solenoid Proportional Valves Ve4020A1195t for Industrial Combustion Burner Controller

Product Description

Honeywell Gas Solenoid Proportional Valves VE4020A1195T For Industrial Combustion Burner Controller

OVERVIEW

    The series "A" class gas valve is used to control and regulate the gas burner, large in gas-fired boilers, furnaces, incinerators and other gas-fired installations the flow of gas.

PRODUCT PARAMETERS

Name	Solenoid Valve
Brand	America
Model	VE4020A1195T
Origin	America
Deliver Time	2~15 days
IP Grade	IP54/IP65
Temperature Range	-18ºC ...+60ºC
Usage	gas burner accessories
Valve Body	Die casting aluminum alloys

  

Features At a Glance

 

Product Features

Normally closed valve.

(Elastic valve disc, automatically restored to closed state when power is off)

On/off type, cannot adjust the flow.

Switching time: less than 1 second. 

Maximum operating frequency: 20 times/min. 

The inlet and outlet ends of the valve have internal threads. 

Two auxiliary 1/4 "bore pressure gauges, both on the intake side. 

Coils can be replaced on site. 

Coil suitable for long-term power supply. 

The coil can be rotated 360 degrees. 

Built-in fine filter.

 

RECOMMEND PRODUCTS

 

WARNING

1,Do not install it in the following places
(1)Places where special drugs or corrosive gases are present (e.g. ammonia, sulfur, hydrochloric acid, ethylene compounds, etc.)
(2)Places where water drops or is too wet.
(3) High temperature places.
(4) A place where the vibration lasts for a long time.
2, Please connect according to the specified basis.
3, In order to prevent electric shock and meter damage, please connect the power supply last. Misunderstanding that touching other subterminals can cause accidents and damage to the meter.
4,The load of each terminal connection should not exceed the rated value.
5,Please use the power supply with the same voltage and frequency as indicated by the machine.
6,For timers and auxiliary relays used as additional functions, please select reliable products and correctly form loops according to your needs.
7,Please ground according to the standard above D type grounding specified in the electrical equipment technical standard, and be sure to ground the burner body.
8,Do not tie the power cord and the high-voltage cable of the ignition transformer with the wire of the flame monitoring rod, and do not put it in the same wire tube, please wire separately.In particular, the high-voltage cable should be distributed separately, 10 cm away from the burner controller Above.
9,Please connect the ignition transformer high-voltage cable reliably to ensure that there is no bad contact. Poor contact will produce high frequency waves, radio noise, etc., causing misoperation. In addition, install the ignition transformer directly with the burner body or the metal part electrically connected to the burner body.
10,After connecting cables, ensure that the cables are correctly connected. Incorrect wiring may damage the unit or cause incorrect actions.

ABOUT US